>Important Terms used in Limit System

>

1. Nominal size. It is the size of a part specified in the drawing as a matter of convenience.
2. Basic size. It is the size of a part to which all limits of variation (i.e. tolerances) are applied to arrive at final dimensioning of the mating parts. The nominal or basic size of a part is often the same.
3. Actual size. It is the actual measured dimension of the part. The difference between the basic size and the actual size should not exceed a certain limit, otherwise it will interfere with the interchangeability of the mating parts.
4. Limits of sizes. There are two extreme permissible sizes for a dimension of the part. The largest permissible size for a dimension of the part is called upper or high or maximum limit, whereas the smallest size of the part is known as lower or minimum limit.
5. Allowance. It is the difference between the basic dimensions of the mating parts. The allowance may be positive or negative. When the shaft size is less than the hole size, then the allowance is positive and when the shaft size is greater than the hole size, then the allowance is negative.
6. Tolerance. It is the difference between the upper limit and lower limit of a dimension. In other words, it is the maximum permissible variation in a dimension. The tolerance may be unilateral or bilateral.
a) When all the tolerance is allowed on one side of the nominal size, then it is said to be unilateral system of tolerance. The unilateral system is mostly used in industries as it permits changing the tolerance value while still retaining the same allowance or type of fit.
b) When the tolerance is allowed on both sides of the nominal size, then it is said to be bilateral system of tolerance.
7. Tolerance zone. It is the zone between the maximum and minimum limit size.
8. Zero line. It is a straight line corresponding to the basic size. The deviations are measured from this line. The positive and negative deviations are shown above and below the zero line
respectively.
9. Upper deviation. It is the algebraic difference between the maximum size and the basic size. The upper deviation of a hole is represented by a symbol ES (Ecart Superior) and of a shaft, it is represented by es.
10.  Lower deviation. It is the algebraic difference between the minimum size and the basic size. The lower deviation of a hole is represented by a symbol EI (Ecart Inferior) and of a shaft, it is represented by ei.
11.  Actual deviation. It is the algebraic difference between an actual size and the corresponding basic size.
12.  Mean deviation. It is the arithmetical mean between the upper and lower deviations.
13.  Fundamental deviation. It is one of the two deviations which is conventionally chosen to define the position of the tolerance zone in relation to zero line.
About these ads
  1. Leave a comment

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Follow

Get every new post delivered to your Inbox.

%d bloggers like this: